Solution for Error "Clean Unable 46" for Brother Printers

I encountered the error message "Clean Unable 46"" with my Brother Printer. For some reasons I have no idea of, it stopped working. Everytime I turn it on, the LCD displays the error message. The LCD suggests to read the manual for troubleshooting. The thing is, I misplaced my guide leaving me searching the Google for a manual source. But, the user manual was of no help. It only stated these probable causes:
a.) The machine has a mechanical problem and/or
b.)Foreign objects such as paper clip or ripped paper is in the machine.

Their solution is to “Open the scanner cover and remove any foreign objects inside the machine. If the error message continues, disconnect the machine from the power for several minutes and then reconnect it.” I followed the instructions as the manual stated. And yet, the it did not worked. I was alarmed that I might need to buy a new printer.

I googled once more and found the cause of the problem. The ink waste pads were full so the only solution is to reset the purge counter or the waste counter. I thought it can only be done by Brother technician until, I found these steps and I was able to fix it. No need to visit the Brother Service Centers. I saved time and effort. =)

Just follow these steps carefully and accurately. This also works with DCP 130C, DCP 110C, DCP 115C, DCP 315CN, DCP 330C, DCP 357C. Good luck!

1. To enter MAINTENANCE Mode, press Menu, then Mono and press UP 4 times.
2. Using arrow up button look for the following:
a. 8 then press SET/OK
b. 0 then press SET/OK
3. Using MONO START, just press it until the word "PURGE XXXXX" comes out.
4. Using arrow up button look for the following:
a. 2 then press SET/OK
b. 7 then press SET/OK
a. 8 then press SET/OK
b. 3 then press SET/OK
This is to reset the purge counter.
When “PURGE 00000” appear press STOP/EXIT
5. Using arrow up button look for the following:
a. 0 then press SET/OK
b. 1 then press SET/OK (To reset unit)
a. 9 then press SET/OK
b. 9 then press SET/OK (To exit Maintenance mode) Your printer should be fine now. I hope I was able to help. :)